Ryobi Quarter Miter Saw. I'll be demonstrating on
a Ryobi model TSS 102L. But the steps are the same for most models of Ryobi Quarter Miter
Saws with laser guides.
To do the adjustment
you'll need a padlock. With the saw unplugged make sure the miter and bevel angles
are set to zero degrees. Using the work clamp secure a piece of material up against the miter fence. Plug the saw back in and make a slight cut, scoring the wood.
Allow the blade to come to a complete stop and raise it back up. Unplug the saw and use your padlock to lock the switch trigger. This will protect against
accidental starting. Plug the saw back in and
turn on the laser guide.
Using the laser adjustment screw turn either clockwise or counterclockwise. The laser is properly aligned when it's lined up with the left edge of the kerf. Once your laser is adjusted and aligned properly you
can remove the padlock. We hope this has been helpful for you.
As always make sure you're wearing the proper safety gear when
you're ready to get to work. If you'd like tips and project
ideas for your Miter Saw visit Ryobitools.Com
and check out Tools 101..
No comments:
Post a Comment